Bgp And Igp Synchronization Configuration - HPE FlexNetwork HSR6800 Configuration Manual

*> 2.2.2.2/32
* 3.1.1.0/24
*> 8.1.1.0/24
*> 9.1.1.0/24
Two routes 2.2.2.2/32 and 9.1.1.0/24 have been added in the routing table of Router A.
# Display the BGP routing table on Router C.
[RouterC] display bgp routing-table
Total Number of Routes: 4
BGP Local router ID is 3.3.3.3
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
Network
i 2.2.2.2/32
*>i 3.1.1.0/24
*>i 8.1.1.0/24
* i 9.1.1.0/24
The output shows that the route 8.1.1.0 becomes valid with the next hop as Router A.
Verify the configuration:
5.
# Ping 8.1.1.1 on Router C.
[RouterC] ping 8.1.1.1
PING 8.1.1.1: 56
Reply from 8.1.1.1: bytes=56 Sequence=1 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=2 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=3 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=4 ttl=254 time=2 ms
Reply from 8.1.1.1: bytes=56 Sequence=5 ttl=254 time=2 ms
--- 8.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/2 ms

BGP and IGP synchronization configuration

Network requirements
As shown in
reside in AS 65009. AS 65008 and AS 65009 are connected through Router A and Router B. It is
required that Router A can access network 9.1.2.0/24 in AS 65009, and Router C can access
network 8.1.1.0/24 in AS 65008.
3.1.1.1
3.1.1.1
0.0.0.0
3.1.1.1
h - history,
Origin : i - IGP, e - EGP, ? - incomplete
NextHop
2.2.2.2
2.2.2.2
3.1.1.2
2.2.2.2
data bytes, press CTRL_C to break
Figure 74, all devices of company A reside in AS 65008 while all devices of company B
0
0
0
0
i - internal, s - suppressed, S - Stale
MED
0
0
0
0
239
0
0
0
0
LocPrf PrefVal Path/Ogn
100 0
100 0
100 0
100 0
65009?
65009?
i
65009?
?
?
65008i
?