HPE FlexNetwork HSR6800 Configuration Manual page 57
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Figure 12 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure basic RIP and enable BFD on the interfaces:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] rip 1
[RouterA-rip-1] network 192.168.1.0
[RouterA-rip-1] quit
[RouterA] interface GigabitEthernet 2//1
[RouterA-GigabitEthernet2/1/1] rip bfd enable
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] rip 2
[RouterA-rip-2] network 192.168.2.0
[RouterA-rip-2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] rip 1
[RouterB-rip-1] network 192.168.2.0
[RouterB-rip-1] network 192.168.3.0
[RouterB-rip-1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.1.0
[RouterC-rip-1] network 192.168.3.0
[RouterC-rip-1] import-route static
[RouterC-rip-1] quit
Configure the BFD parameters on GigabitEthernet 2/1/1 of Router A:
3.
[RouterA] bfd session init-mode active
[RouterA] bfd echo-source-ip 11.11.11.11
[RouterA] interface GigabitEthernet 2/1
[RouterA-GigabitEthernet2/1/1] bfd min-echo-transmit-interval 500
[RouterA-GigabitEthernet2/1/1] bfd min-receive-interval 500
[RouterA-GigabitEthernet2/1/1] bfd detect-multiplier 7
[RouterA-GigabitEthernet2/1/1] return
45
Advertisement
Table of Contents
Troubleshooting
