HPE FlexNetwork HSR6800 Configuration Manual page 69
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Backbone area and virtual links
Each AS has a backbone area that distributes routing information between non-backbone areas.
Routing information between non-backbone areas must be forwarded by the backbone area. OSPF
requires the following:
•
All non-backbone areas must maintain connectivity to the backbone area.
•
The backbone area must maintain connectivity within itself.
In practice, the requirements might not be met due to lack of physical links. OSPF virtual links can
resolve this issue.
A virtual link is established between two ABRs through a non-backbone area and is configured on
both ABRs to take effect. The non-backbone area is called a transit area.
In
Figure
16, Area 2 has no direct physical link to the backbone area 0. You can configure a virtual
link between the two ABRs to connect Area 2 to the backbone area.
Figure 16 Virtual link application 1
Virtual links can also be used to provide redundant links. If the backbone area cannot maintain
internal connectivity due to the failure of a physical link, you can configure a virtual link to replace the
failed physical link, as shown in
Figure 17 Virtual link application 2
The virtual link between the two ABRs acts as a point-to-point connection. You can configure
interface parameters, such as hello interval, on the virtual link as they are configured on a physical
interface.
The two ABRs on the virtual link unicast OSPF packets to each other, and the OSPF routers in
between convey these OSPF packets as normal IP packets.
Stub area and totally stub area
A stub area does not distribute Type-5 LSAs to reduce the routing table size and the LSAs advertised
within the area. The ABR of the stub area advertises a default route in a Type-3 LSA so that the
routers in the area can reach external networks through the default route.
To further reduce the routing table size and advertised LSAs, you can configure the stub area as a
totally stub area. The ABR of a totally stub area does no advertise inter-area routes or external
Figure
17.
57
Advertisement
Table of Contents
Troubleshooting
