HPE FlexNetwork HSR6800 Configuration Manual page 181

[RouterS] slave switchover enable
[RouterS] slave switchover
Caution!!! Confirm to switch slave to master? [Y/N]:Y
# Display IS-IS neighbors and routes on Router A.
<RouterA> display isis peer
Peer information for ISIS(1)
System Id: 0000.0000.0001
Interface: GE2/1/1
State: Up HoldTime: 25s
System Id: 0000.0000.0001
Interface: GE2/1/1
State: Up HoldTime: 27s
<RouterA> display isis route
Route information for ISIS(1)
IPV4 Destination
--------------------------------------------------------------------------
12.12.12.0/24
22.22.22.22/32
14.14.14.0/32
44.44.44.44/32
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
IPV4 Destination
--------------------------------------------------------------------------
12.12.12.0/24
22.22.22.22/32
14.14.14.0/32
44.44.44.44/32
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
# Display IS-IS neighbors and routes on Router B.
<RouterB> display isis peer
Peer information for ISIS(1)
----------------------------
Circuit Id: 0000.0000.0001.01
Type: L1(L1L2)
Circuit Id: 0000.0000.0001.01
Type: L2(L1L2)
-----------------------------
ISIS(1) IPv4 Level-1 Forwarding Table
-------------------------------------
IntCost ExtCost ExitInterface
10 NULL
10 NULL
10 NULL
10 NULL
ISIS(1) IPv4 Level-2 Forwarding Table
-------------------------------------
IntCost ExtCost ExitInterface
10 NULL
10 NULL
10 NULL
10 NULL
----------------------------
169
PRI: 64
PRI: 64
NextHop
GE2/1/1 Direct
Loop0 Direct
GE2/1/1 12.12.12.2
GE2/1/1 12.12.12.2
NextHop
GE2/1/1 Direct
Loop0 Direct
Flags
D/L/-
D/-/-
R/L/-
R/L/-
Flags
D/L/-
D/-/-