HPE FlexNetwork HSR6800 Configuration Manual page 332

Neighbor ID
2.2.2.2
OSPFv3 Area ID 0.0.0.2 (Process 1)
----------------------------------------------------------------------
Neighbor ID
4.4.4.4
# Display OSPFv3 routing information on Router D.
[RouterD] display ospfv3 routing
I - Intra area route,
IA - Inter area route,
* - Selected route
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: 2001::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:1::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:2::/64
Type : I
NextHop : directly-connected
*Destination: 2001:3::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
Configure Area 2 as a stub area:
3.
# Configure Router D.
[RouterD] ospfv3
[RouterD-ospfv3-1] area 2
[RouterD-ospfv3-1-area-0.0.0.2] stub
# Configure Router C, and specify the cost of the default route sent to the stub area as 10.
[RouterC] ospfv3
[RouterC-ospfv3-1] area 2
[RouterC-ospfv3-1-area-0.0.0.2] stub
[RouterC-ospfv3-1-area-0.0.0.2] default-cost 10
# Display OSPFv3 routing information on Router D. A default route is added and its cost is the
cost of a direct route plus the configured cost.
[RouterD] display ospfv3 routing
I - Intra area route,
IA - Inter area route,
E2 - Type 2 external route,
Pri State
1 Full/DR
Pri State
1 Full/Backup
E1 - Type 1 external route,
E2 – Type 2 external route,
E1 - Type 1 external route,
E2 – Type 2 external route,
* - Seleted route
320
Dead Time Interface
00:00:35 GE2/2/0
Dead Time Interface
00:00:36 GE2/2/1
N1 – Type 1 NSSA route
Cost
Interface: GE2/2/1
Cost
Interface: GE2/2/1
Cost
Interface: GE2/2/1
Cost
Interface: GE2/2/1
N1 – Type 1 NSSA route
Instance ID
0
Instance ID
0
N2 – Type 2 NSSA route
: 2
: 3
: 1
: 4
N2 – Type 2 NSSA route