Disabling Host Route Reception; Advertising A Default Route - HPE FlexNetwork HSR6800 Configuration Manual

Step
Enter system view.
1.
Enter RIP view.
2.
Disable RIPv2 automatic
3.
route summarization.
Return to system view.
4.
Enter interface view.
5.
Configure a summary route.
6.

Disabling host route reception

Perform this task to disable RIPv2 from receiving host routes from the same network and save
network resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Step
Enter system view.
1.
Enter RIP view.
2.
Disable RIP from receiving
3.
host routes.

Advertising a default route

You can advertise a default route on all RIP interfaces in RIP view or a specific RIP interface in
interface view. The interface view setting takes precedence over the RIP view settings.
To disable an interface from advertising a default route, use the rip default-route no-originate
command on the interface.
To configure RIP to advertise a default route:
Step
Enter system view.
1.
Enter RIP view.
2.
Enable RIP to advertise a
3.
default route.
Return to system view.
4.
Enter interface view.
5.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
undo summary
quit
interface interface-type
interface-number
rip summary-address
ip-address { mask | mask-length }
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
undo host-route
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
default-route { only | originate }
[ cost cost ]
quit
interface interface-type
interface-number
26
Remarks
N/A
N/A
By default, RIPv2 automatic route
summarization is enabled.
N/A
N/A
N/A
Remarks
N/A
N/A
By default, RIP receives host
routes.
Remarks
N/A
N/A
Optional.
Not enabled by default.
N/A
N/A