HPE FlexNetwork HSR6800 Configuration Manual page 272
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Configure OSPF so that Router A and Router C are reachable to each other. (Details not
2.
shown.)
Configure BGP on Router A:
3.
# Establish two IBGP connections to Router C.
<RouterA> system-view
[RouterA] bgp 200
[RouterA-bgp] peer 3.0.2.2 as-number 200
[RouterA-bgp] peer 2.0.2.2 as-number 200
[RouterA-bgp] quit
# Create ACL 2000 to permit 1.1.1.0/24 to pass.
[RouterA] acl number 2000
[RouterA-acl-basic-2000] rule permit source 1.1.1.0 0.0.0.255
[RouterA-acl-basic-2000] quit
# Create two route policies, apply_med_50 and apply_med_100. Policy apply_med_50 sets
the MED for route 1.1.1.0/24 to 50. Policy apply_med_100 sets that to 100.
[RouterA] route-policy apply_med_50 permit node 10
[RouterA-route-policy] if-match acl 2000
[RouterA-route-policy] apply cost 50
[RouterA-route-policy] quit
[RouterA] route-policy apply_med_100 permit node 10
[RouterA-route-policy] if-match acl 2000
[RouterA-route-policy] apply cost 100
[RouterA-route-policy] quit
# Apply routing policy apply_med_50 to routes outgoing to peer 3.0.2.2, and apply routing
policy apply_med_100 to routes outgoing to peer 2.0.2.2.
[RouterA] bgp 200
[RouterA-bgp] peer 3.0.2.2 route-policy apply_med_50 export
[RouterA-bgp] peer 2.0.2.2 route-policy apply_med_100 export
# Enable BFD for peer 3.0.2.2.
[RouterA-bgp] peer 3.0.2.2 bfd
[RouterA-bgp] quit
Configure BGP on Router C:
4.
<RouterC> system-view
[RouterC] bgp 200
[RouterC-bgp] peer 3.0.1.1 as-number 200
[RouterC-bgp] peer 3.0.1.1 bfd
[RouterC-bgp] peer 2.0.1.1 as-number 200
[RouterC-bgp] quit
Configure BFD parameters (you can use default BFD parameters instead):
5.
# Configure Router A.
Configure active-mode BFD on GigabitEthernet 2/1/2.
[RouterA] bfd session init-mode active
[RouterA] interface gigabitethernet 2/1/2
Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[RouterA-GigabitEthernet2/1/2] bfd min-transmit-interval 500
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[RouterA-GigabitEthernet2/1/2] bfd min-receive-interval 500
Configure the detect multiplier as 7.
260
Advertisement
Table of Contents
Troubleshooting
