HPE FlexNetwork HSR6800 Configuration Manual page 340

Figure 100 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown.)
1.
Configure OSPFv3 basic functions:
2.
# On Router A, enable OSPFv3 process 1, enable GR, and set the router ID to 1.1.1.1.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] graceful-restart enable
[RouterA-ospfv3-1] quit
[RouterA] interface GigabitEthernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ospfv3 1 area 1
[RouterA-GigabitEthernet2/1/1] quit
# Enable OSPFv3 on Router B and set the router ID to 2.2.2.2. (By default, GR helper is
enabled on a router.)
<RouterB> system-view
[RouterB] ipv6
[RouterB] ospfv3 1
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface GigabitEthernet 2/1/1
[RouterB-GigabitEthernet2/1/1] ospfv3 1 area 1
[RouterB-GigabitEthernet2/1/1] quit
# Enable OSPFv3 on Router C and set the router ID to 3.3.3.3. (By default, GR helper is
enabled on a router.)
<RouterC> system-view
[RouterC] ipv6
[RouterC] ospfv3 1
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface GigabitEthernet 2/1/1
[RouterC-GigabitEthernet2/1/1] ospfv3 1 area 1
[RouterC-GigabitEthernet2/1/1] quit
328