Configuring The Maximum Number Of External Lsas In Lsdb; Enabling Compatibility With Rfc 1583; Logging Neighbor State Changes; Configuring Ospf Network Management - HPE FlexNetwork HSR6800 Configuration Manual

Configuring the maximum number of external LSAs in LSDB

To configure the maximum number of external LSAs in the LSDB:
Step
Enter system view.
1.
Enter OSPF view.
2.
Specify the maximum
3.
number of external LSAs in
the LSDB.

Enabling compatibility with RFC 1583

RFC 1583 specifies a different method than RFC 2328 for selecting an external route from multiple
LSAs. This task enables RFC 2328 to be compatible with RFC 1583 so that the intra-area route in
the backbone area is preferred. If they are not compatible, the intra-area route in a non-backbone
area is preferred to reduce the burden of the backbone area.
To avoid routing loops, configure all the routers in a routing domain to be either compatible or
incompatible with RFC 1583.
To make them compatible:
Step
Enter system view.
1.
Enter OSPF view.
2.
Enable compatibility
3.
with RFC 1583.

Logging neighbor state changes

Perform this task to enable output of log information to the terminal upon neighbor state changes.
To enable the logging of neighbor state changes:
Step
Enter system view.
1.
Enter OSPF view.
2.
Enable the logging of
3.
neighbor state changes.

Configuring OSPF network management

With trap generation enabled, OSPF generates traps to report important events. Traps include the
following levels:
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
lsdb-overflow-limit number
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
rfc1583 compatible
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
log-peer-change
79
Remarks
N/A
N/A
Optional.
Not specified by
default.
Remarks
N/A
N/A
Optional.
Enabled by default.
Remarks
N/A
N/A
Optional.
Enabled by default.