Enabling Ospfv3; Configuration Prerequisites - HPE FlexNetwork HSR6800 Configuration Manual

Task
optimizing
OSPFv3
networks
Configuring
OSPFv3 GR
Configuring BFD for OSPFv3
Applying IPsec policies for OSPFv3

Enabling OSPFv3

Configuration prerequisites

Before you enable OSPFv3, complete the following tasks:
•
Make neighboring nodes accessible with each other at the network layer.
•
Enable IPv6 packet forwarding.
Enabling OSPFv3
To enable an OSPFv3 process on a router, you must enable the OSPFv3 process globally, assign
the OSPFv3 process a router ID, and enable the OSPFv3 process on related interfaces.
A router ID uniquely identifies a router within an AS. You must specify a unique router ID for each
OSPFv3 router within the AS to ensure proper operation. If a router runs multiple OSPFv3 processes,
specify a unique router ID for each process.
An OSPFv3 process ID has only local significance. Process 1 on a router can exchange packets with
process 2 on another router.
For more information about VPN instances, see MPLS Configuration Guide.
To enable OSPFv3:
Step
Enter system view.
1.
Enable an OSPFv3 process
2.
and enter its view.
Specify a router ID.
3.
Enter interface view.
4.
Enable an OSPFv3 process
5.
on the interface.
Configuring a DR priority for an interface
Ignoring MTU check for DD packets
Disabling interfaces from receiving and sending OSPFv3
packets
Enabling the logging of neighbor state changes
Configuring GR restarter
Configuring GR helper
Command
system-view
ospfv3 [ process-id ]
[ vpn-instance
vpn-instance-name ]
router-id router-id
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
305
Remarks
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
By default, no OSPFv3 process is
enabled.
N/A
N/A
Not enabled by default.