HPE FlexNetwork HSR6800 Configuration Manual page 60

Figure 13 Network diagram
192.168.2.2/24
Router A
RIP packets
BFD session
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure basic RIP and enable BFD on the interfaces:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] rip 1
[RouterA-rip-1] network 192.168.2.0
[RouterA-rip-1] import-route static
[RouterA-rip-1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] rip bfd enable destination 192.168.2.2
[RouterA-GigabitEthernet2/1/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] rip 1
[RouterB-rip-1] network 192.168.2.0
[RouterB-rip-1] network 192.168.3.0
[RouterB-rip-1] quit
# Configure Router C.
<
RouterC> system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.3.0
[RouterC-rip-1] import-route static cost 3
[RouterC-rip-1] quit
Configure BFD parameters on GigabitEthernet 2/1/2 of Router A.
3.
[RouterA] bfd echo-source-ip 11.11.11.11
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] bfd min-echo-receive-interval 500
[RouterA-GigabitEthernet2/1/2] quit
Configure static routes:
4.
# Configure a static route on Router A.
[RouterA] ip route-static 100.1.1.0 24 null 0
# Configure a static route on Router C.
[RouterC] ip route-static 100.1.1.0 24 null 0
Router B
GE2/1/1 GE2/1/2
192.168.3.1/24
Fault
GE2/1/2
192.168.3.2/24
Router C
48