Configure Static Routes - HPE FlexNetwork HSR6800 Configuration Manual

# Configure Router B.
<RouterB> system-view
[RouterB] interface GigabitEthernet 2/1/2
[RouterB-GigabitEthernet2/1/2] ip address 192.168.1.2 24
[RouterB-GigabitEthernet2/1/2] quit
[RouterB] interface GigabitEthernet 2/1/1
[RouterB-GigabitEthernet2/1/1] ip address 192.168.2.1 24
# Configure Router C.
[RouterC] bfd session init-mode active
[RouterC] interface GigabitEthernet 2/1/1
[RouterC-GigabitEthernet2/1/1] ip address 192.168.2.2 24
[RouterC-GigabitEthernet2/1/1] bfd min-transmit-interval 500
[RouterC-GigabitEthernet2/1/1] bfd min-receive-interval 500
[RouterC-GigabitEthernet2/1/1] bfd detect-multiplier 6
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface GigabitEthernet 2/1/2
[RouterC-GigabitEthernet2/1/2] ip address 192.168.4.2 24
[RouterC-GigabitEthernet2/1/2] quit
# Configure Router D.
[RouterD] interface GigabitEthernet 2/1/2
[RouterD-GigabitEthernet2/1/2] ip address 192.168.4.1 24
[RouterD-GigabitEthernet2/1/2] quit
[RouterD] interface GigabitEthernet 2/1/1
[RouterD-GigabitEthernet2/1/1] ip address 192.168.3.2 24
[RouterD-GigabitEthernet2/1/1] quit

Configure static routes:

4.
# Configure a static route to Router C on Router A.
[RouterA] ip route-static 192.168.2.0 24 GigabitEthernet2/1/2 192.168.1.2
[RouterA] quit
# Configure a static route to Router A on Router C.
[RouterC] ip route-static 192.168.1.0 24 GigabitEthernet2/1/1 192.168.2.1
Verify the configuration:
5.
# Display the BFD session information of Router A.
<RouterA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD
6/1
# Display RIP routes destined for 100.1.1.0/24 learned on Router A.
<RouterA> display ip routing-table 100.1.1.0 verbose
Routing Table : Public
Summary Count : 2
Destination: 100.1.1.0/24
Protocol: RIP
Preference: 100
IpPrecedence:
NextHop: 192.168.2.2
Init Mode: Active
SourceAddr DestAddr
192.168.1.1 192.168.2.2
Process ID: 1
Interface: GigabitEthernet2/1/2
52
State Holdtime Interface
Up
Cost: 1
QosLcId:
1700ms GE2/1/2