HPE FlexNetwork HSR6800 Configuration Manual page 25

[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/1 12.1.1.1 bfd
control-packet
[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/2 13.1.1.2 preference 65
[RouterB] quit
# Configure static routes on Router C.
<RouterC> system-view
[RouterC] ip route-static 120.1.1.0 24 GigabitEthernet 2/1/2 13.1.1.1
[RouterC] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/1 10.1.1.102
Verify the configuration:
3.
# Display BFD sessions on Router A.
<RouterA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD
4/7
The output shows that the BFD session has been created.
# Display static routes on Router A. The static route to Router B through the Layer 2 switch is
displayed in the output.
<RouterA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Direct Routing table Status : <Inactive>
Summary Count : 1
Destination/Mask
120.1.1.0/24
# Enable BFD debugging. When the link between Router A and the switch fails, Router A can
detect the failure.
<RouterA> debugging bfd event
<RouterA> debugging bfd scm
<RouterA> terminal debugging
%Jul 27 10:18:18:672 2007 RouterA BFD/4/LOG:Sess[12.1.1.1/12.1.1.2,
GigabitEthernet2/1/1,Ctrl], Sta: UP->DOWN, Diag: 1
*Jul 27 10:18:18:672 2007 RouterA BFD/7/EVENT:Send sess-down Msg,
[Src:12.1.1.1,Dst:12.1.1.2,GigabitEthernet2/1/1,Ctrl], instance:0, protocol:STATIC
*Jul 27 10:18:19:172 2007 RouterA BFD/7/EVENT:Receive Delete-sess,
[Src:12.1.1.1,Dst:12.1.1.2,GigabitEthernet2/1/1,Ctrl], Direct, Instance:0x0,
Proto:STATIC
#*Jul 27 10:18:19:172 2007 RouterA BFD/7/EVENT:Notify driver to stop receiving bf
Init Mode: Active
SourceAddr DestAddr
12.1.1.1 12.1.1.2
Proto Pre Cost
Static 60 0
Proto Pre Cost
Static 65 0
13
State Holdtime Interface
Up 2000ms GigabitEthernet2/1/1
NextHop Interface
12.1.1.2 GE2/1/1
NextHop Interface
10.1.1.100 GE2/1/2