HPE FlexNetwork HSR6800 Configuration Manual page 394

[PE1-ospf-1-area-0.0.0.0] network 3.3.3.3 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 1.1.0.0 0.0.255.255
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
[PE1]
Configure CE 2:
4.
# Enable IPv6 packet forwarding and specify IP addresses for interfaces.
<CE2> system-view
[CE2] ipv6
[CE2] interface serial 2/2/0
[CE2-Serial2/2/0] ipv6 address auto link-local
[CE2-Serial2/2/0] quit
[CE2] interface loopback 0
[CE2-LoopBack0] ipv6 address 4::4/128
[CE2-LoopBack0] quit
# Configure the static route to PE 2.
[CE2] ipv6 route-static :: 0 serial2/2/0
Verify the configuration:
5.
# Display MPLS LSP information on PE 1.
<PE1> display mpls lsp
--------------------------------------------------------------
--------------------------------------------------------------
FEC
In Label
In Interface
Vrf Name
FEC
In Label
In Interface
Vrf Name
---------------------------------------------------------------
---------------------------------------------------------------
FEC
3.3.3.3/32
2.2.2.2/32
# Display the IPv6 BGP routing table on PE 1.
<PE1> display bgp ipv6 routing-table
Total Number of Routes: 4
BGP Local router ID is 2.2.2.2
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
*> Network : 1::1
LSP Information: BGP IPV6 LSP
: 1::1
: 1024
: -----
:
: 2::2
: 1025
: -----
:
LSP Information: LDP LSP
In/Out Label In/Out IF
NULL/3 -/S2/1
3/NULL S2/1/-
h - history, i - internal, s - suppressed, S – Stale
Origin : i - IGP, e - EGP, ? - incomplete
382
Out Label : -----
OutInterface : -----
Out Label : -----
OutInterface : -----
Vrf Name
PrefixLen : 128