HPE FlexNetwork HSR6800 Configuration Manual page 113

[RouterC] ospf
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
# Configure Router D.
<RouterD> system-view
[RouterD] router id 4.4.4.4
[RouterD] ospf
[RouterD-ospf-1] area 0
[RouterD-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.0] quit
[RouterD-ospf-1] return
# Display neighbor information on Router A.
[RouterA] display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.1
Area 0.0.0.0 interface 192.168.1.1(GigabitEthernet2/1/1)'s neighbors
Router ID: 2.2.2.2
State: 2-Way
DR: 192.168.1.4
Dead timer due in 38
Neighbor is up for 00:01:31
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.4
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
Router ID: 4.4.4.4
State: Full
DR: 192.168.1.4
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
The output shows that Router D is the DR and Router C is the BDR.
Configure router priorities on interfaces:
3.
# Configure Router A.
[RouterA] interface GigabitEthernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ospf dr-priority 100
[RouterA-GigabitEthernet2/1/1] quit
# Configure Router B.
[RouterB] interface GigabitEthernet 2/1/1
Neighbors
Address: 192.168.1.2
Mode: None Priority: 1
BDR: 192.168.1.3
sec
Address: 192.168.1.3
Mode: Nbr is Master
BDR: 192.168.1.3
sec
Address: 192.168.1.4
Mode: Nbr is Master
BDR: 192.168.1.3
sec
101
GR State: Normal
MTU: 0
GR State: Normal
Priority: 1
MTU: 0
GR State: Normal
Priority: 1
MTU: 0