Configuring Actions For A Node - HPE FlexNetwork HSR6800 Configuration Manual

Step
Configure a packet length
4.
match criterion.
Configure a reverse input
5.
interface match criterion.

Configuring actions for a node

Step
Enter system view.
1.
Enter policy node view.
2.
Set the DF bit in the IP
3.
header to 0.
Set VPN instances.
4.
Set an IP precedence.
5.
Set output interfaces.
6.
Set next hops.
7.
Set two next hops to operate
8.
in active/standby mode.
Set default output
9.
interfaces.
10. Set default next hops.
Command
if-match packet-length min-len max-len
if-match reverse-input-interface
interface-type interface-number
Command
system-view
policy-based-route policy-name
[ deny | permit ] node
node-number
apply ip-df zero
apply access-vpn vpn-instance
vpn-instance-name&<1-6>
apply ip-precedence value
apply output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
apply ip-address next-hop
ip-address [ direct ] [ track
track-entry-number ] [ ip-address
[ direct ] [ track
track-entry-number ] ]
apply ip-address next-hop
standby
apply default output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
apply ip-address default
next-hop ip-address [ direct ]
[ track track-entry-number ]
[ ip-address [ direct ] [ track
track-entry-number ] ]
269
Remarks
Optional.
Optional.
Remarks
N/A
N/A
Optional.
Setting the DF bit in the IP header
to 0 means the packet can be
fragmented
Optional.
Optional.
Optional.
You can specify up to two output
interfaces to achieve load
sharing.
For non-P2P interfaces
(broadcast and NBMA
interfaces), such as Ethernet
interfaces, packet forwarding
might fail due to multiple next
hops.
Optional.
You can specify up to two next
hops to achieve load sharing.
If the standby keyword is
specified, active/standby mode
load sharing is implemented.
Optional.
By default, both next hops take
effect to achieve load sharing.
Optional.
You can specify up to two default
output interfaces to achieve load
sharing.
Optional.
You can specify up to two default
next hops to achieve load
sharing.