Configuring Is-Is Basic Functions; Configuration Prerequisites; Enabling Is-Is - HPE FlexNetwork HSR6800 Configuration Manual

Task
Enhancing IS-IS
network security
Configuring IS-IS GR
Configuring IS-IS NSR
Configuring IS-IS FRR
Enabling IS-IS SNMP trap
Binding an IS-IS process with MIBs
Configuring BFD for IS-IS
Configuring IS-IS MTR

Configuring IS-IS basic functions

This section describes the basic settings required for an IS-IS network to run.

Configuration prerequisites

Before the configuration, complete the following tasks:
•
Configure the link layer protocol.
•
Configure IP addresses for all interfaces, and make sure that all neighboring nodes are
reachable to each other at the network layer.

Enabling IS-IS

Step
Enter system view.
1.
Enable the IS-IS routing
2.
process and enter its view.
Assign a network entity title.
3.
Return to system view.
4.
Enter interface view.
5.
Enable an IS-IS process on
6.
the interface.
Setting the LSDB overload bit
Configuring system ID to host name mappings
Enabling the logging of neighbor state changes
Configuring neighbor relationship authentication
Configuring area authentication
Configuring routing domain authentication
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
network-entity net
quit
interface interface-type
interface-number
isis enable [ process-id ]
133
Remarks
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
Not enabled by default.
Not assigned by default.
N/A
N/A
Disabled by default.