Configuring Received/Redistributed Route Filtering; Configuring A Preference For Rip - HPE FlexNetwork HSR6800 Configuration Manual
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Step
Configure the RIP interface
6.
to advertise a default route.
NOTE:
The router enabled to advertise a default route does not receive default routes from RIP neighbors.
Configuring received/redistributed route filtering
Perform this task to filter received and redistributed routes by using an ACL or IP prefix list. You can
also configure RIP to receive routes only from a specified neighbor.
To configure route filtering:
Step
Enter system view.
1.
Enter RIP view.
2.
Configure the filtering of
3.
received routes.
Configure the filtering of
4.
redistributed routes.
Configuring a preference for RIP
If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest
priority is selected as the optimal route. Perform this task to configure a preference for RIP. The
smaller the preference value, the higher the priority.
To configure a preference for RIP:
Step
Enter system view.
1.
Enter RIP view.
2.
Configure a preference for
3.
RIP.
Command
rip default-route { { only |
originate } [ cost cost ] |
no-originate }
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
filter-policy { acl-number |
gateway ip-prefix-name |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] }
import [ interface-type
interface-number ]
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] |
interface-type interface-number ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
preference [ route-policy
route-policy-name ] value
27
Remarks
Optional.
By default, a RIP interface can
advertise a default route if the RIP
process is configured with default
route advertisement.
Remarks
N/A
N/A
By default, the filtering of received
routes is not configured.
The filter-policy import
command filters received routes.
Filtered routes are not installed
into the routing table or advertised
to neighbors.
By default, the filtering of
redistributed routes is not
configured.
The filter-policy export
command filters redistributed
routes, including routes
redistributed with the
import-route command.
Remarks
N/A
N/A
Optional.
The default setting is 100.
Advertisement
Table of Contents
Troubleshooting
