Configuring Ipv6 Pbr; Configuring Ipv6 Local Pbr; Configuring Ipv6 Interface Pbr - HPE FlexNetwork HSR6800 Configuration Manual
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Step
Set a next hop for permitted
5.
IPv6 packets.
Set a default output interface
6.
for permitted IPv6 packets.
Set a default next hop for
7.
permitted IPv6 packets.
Matches packets against the
8.
next node upon match failure
on the current node.
NOTE:
If a local Ethernet interface or sub Ethernet interface is specified as the output interface, packets
can be forwarded through the interface but the forwarding might fail, because the interface is a
broadcast interface. You need to specify a next hop.
Configuring IPv6 PBR
Configuring IPv6 local PBR
Configure IPv6 PBR by applying a policy locally. IPv6 PBR uses the policy to guide the forwarding of
locally generated packets.
You can apply only one policy locally. If you perform the ipv6 local policy-based-route command
multiple times, only the last specified policy takes effect.
Do not configure IPv6 local PBR unless required.
If the specified policy does not exist, the IPv6 local PBR configuration succeeds, but it does not takes
effect until the policy is created.
To configure IPv6 local PBR:
Step
Enter system view.
1.
Apply an IPv6 policy locally.
2.
Configuring IPv6 interface PBR
Configure PBR by applying an IPv6 policy on an interface. IPv6 PBR uses the policy to guide the
forwarding of packets received on the interface.
You can apply only one policy on an interface. If you perform the ipv6 policy-based-route command
multiple times, only the last specified policy takes effect.
Command
apply ipv6-address next-hop
ipv6-address
apply default output-interface
interface-type interface-number
apply ipv6-address default
next-hop ipv6-address
apply fail-action continue
Command
system-view
ipv6 local policy-based-route
policy-name
396
Remarks
Optional.
You can define five next hops
at most for load balancing.
Optional.
You can specify up to five
output interfaces to achieve
load sharing.
Optional.
You can specify up to five
output interfaces to achieve
load sharing.
Optional.
Use this command only when
the match mode of the node is
permit.
Remarks
N/A
Not applied by default.
Advertisement
Table of Contents
Troubleshooting
