Configuring The Maximum Number Of Ospfv3 Ecmp Routes; Configuring A Priority For Ospfv3; Configuring Ospfv3 Route Redistribution - HPE FlexNetwork HSR6800 Configuration Manual

Step
Configure an OSPFv3
3.
cost for the interface.
To configure a bandwidth reference value:
Step
Enter system view.
1.
Enter OSPFv3 view.
2.
Configure a bandwidth
3.
reference value.

Configuring the maximum number of OSPFv3 ECMP routes

Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Step
Enter system view.
1.
Enter OSPFv3 view.
2.
Specify the maximum
3.
number of ECMP routes.

Configuring a priority for OSPFv3

A router can run multiple routing protocols. The system assigns a priority to each protocol. When
these routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
To configure a priority for OSPFv3:
Step
Enter system view.
1.
Enter OSPFv3 view.
2.
Configure a priority for
3.
OSPFv3.

Configuring OSPFv3 route redistribution

When you configure OSPFv3 route redistribution, follow these guidelines:
Command
ospfv3 cost value
[ instance instance-id ]
Command
system-view
ospfv3 [ process-id ]
bandwidth-reference value
Command
system-view
ospfv3 [ process-id ]
maximum load-balancing
maximum
Command
system-view
ospfv3 [ process-id ]
preference [ ase ]
[ route-policy
route-policy-name ] preference
310
Remarks
Optional.
The default cost depends on the interface
type: 1 for a VLAN interface; 0 for a loopback
interface; computed according to the
bandwidth for other interfaces.
Remarks
N/A
N/A
Optional.
100 Mbps by default.
Remarks
N/A
N/A
Optional.
By default, he maximum number
of ECMP routes is 8.
Remarks
N/A
N/A
Optional.
By default, the priority of OSPFv3
internal routes is 10, and the priority of
OSPFv3 external routes is 150.