HPE FlexNetwork HSR6800 Configuration Manual page 122

Figure 31 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure OSPF basic functions (see
2.
Configure OSPF to redistribute routes:
3.
# On Router C, configure a static route destined for network 3.1.1.0/24.
<RouterC> system-view
[RouterC] ip route-static 3.1.1.0 24 10.4.1.2
# On Router C, configure a static route destined for network 3.1.2.0/24.
[RouterC] ip route-static 3.1.2.0 24 10.4.1.2
# On Router C, configure a static route destined for network 3.1.3.0/24.
[RouterC] ip route-static 3.1.3.0 24 10.4.1.2
# Configure OSPF to redistribute static routes on Router C.
[RouterC] ospf 1
[RouterC-ospf-1] import-route static
[RouterC-ospf-1] quit
# Display the OSPF routing table of Router A.
<RouterA> display ip routing-table
Routing Tables: Public
Destination/Mask
3.1.1.0/24
3.1.2.0/24
3.1.3.0/24
10.1.1.0/24
10.1.1.1/32
10.2.1.0/24
10.2.1.1/32
10.3.1.0/24
10.4.1.0/24
10.5.1.0/24
127.0.0.0/8
127.0.0.1/32
Configure Router C to filter out the route 3.1.3.0/24:
4.
Destinations : 12
Proto Pre
O_ASE 150
O_ASE 150
O_ASE 150
Direct 0
Direct 0
Direct 0
Direct 0
OSPF 10
OSPF 10
OSPF 10
Direct 0
Direct 0
"Configuring OSPF basic
Routes : 12
Cost NextHop
1 10.2.1.2
1 10.2.1.2
1 10.2.1.2
0 10.1.1.1
0 127.0.0.1
0 10.2.1.1
0 127.0.0.1
4 10.1.1.2
13 10.2.1.2
14 10.1.1.2
0 127.0.0.1
0 127.0.0.1
110
functions").
Interface
GE2/1/2
GE2/1/2
GE2/1/2
GE2/1/1
InLoop0
GE2/1/2
InLoop0
GE2/1/1
GE2/1/2
GE2/1/1
InLoop0
InLoop0