Configuring Ospf Dr Election - HPE FlexNetwork HSR6800 Configuration Manual

Destination
3.1.2.0/24
Total Nets: 6
Intra Area: 2
The output shows an external route imported from the NSSA area on Router D.

Configuring OSPF DR election

Network requirements
•
Enable OSPF on Routers A, B, C, and D on the same network.
•
Configure Router A as the DR and configure Router C as the BDR.
Figure 27 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure OSPF basic functions:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] router id 1.1.1.1
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
[RouterA-ospf-1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] router id 2.2.2.2
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] router id 3.3.3.3
Cost Type
1 Type2
Inter Area: 3 ASE: 1
100
Tag NextHop
1 10.3.1.1
NSSA: 0
AdvRouter
10.2.1.1