Configuring Ipv6 Interface Pbr Based On Packet Type - HPE FlexNetwork HSR6800 Configuration Manual

[RouterC] interface serial 2/2/1
[RouterC-Serial2/2/1] ipv6 address 2::2 64
Verify the configuration:
4.
# Telnet to Router B (1::2/64) from Router A. The operation succeeds.
# Telnet to Router C (2::2/64) from Router A. The operation fails.
# Ping Router C (2::2/64) from Router A. The operation succeeds.
Telnet uses TCP, and ping uses ICMP. The preceding results indicate that all TCP packets of
Router A are forwarded through Serial 2/2/0, and other packets are forwarded through Serial
2/2/1. The IPv6 local PBR configuration is effective.

Configuring IPv6 interface PBR based on packet type

Network requirements
As shown in
received on GigabitEthernet 2/1/1 through Serial 2/2/0. Router A forwards other IPv6 packets
according to the routing table.
Figure 114 Network diagram
Configuration procedure
Configure Router A:
1.
# Configure RIPng.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface serial 2/2/0
[RouterA-Serial2/2/0] ipv6 address 1::1 64
[RouterA-Serial2/2/0] ripng 1 enable
[RouterA-Serial2/2/0] quit
Figure 114, configure IPv6 interface PBR on Router A to forward all TCP packets
399