HPE FlexNetwork HSR6800 Configuration Manual page 63

Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure basic RIP basic and enable static route redistribution into RIP so Router A and
2.
Router C have routes to send to each other:
# Configure Router A.
<RouterA> system-view
[RouterA] rip 1
[RouterA-rip-1] network 192.168.1.0
[RouterA-rip-1] peer 192.168.2.2
[RouterA-rip-1] undo validate-source-address
[RouterA-rip-1] import-route static
[RouterA-rip-1] quit
[RouterA] interface GigabitEthernet 2/1/2
[RouterA-GigabitEthernet2/1/2] rip bfd enable
[RouterA-GigabitEthernet2/1/2] quit
[RouterA] rip 2
[RouterA-rip-2] network 192.168.3.0
[RouterA-rip-2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.2.0
[RouterC-rip-1] network 192.168.4.0
[RouterC-rip-1] peer 192.168.1.1
[RouterC-rip-1] undo validate-source-address
[RouterC-rip-1] import-route static
[RouterC-rip-1] quit
[RouterC] interface GigabitEthernet 2/1/1
[RouterC-GigabitEthernet2/1/1] rip bfd enable
[RouterC-GigabitEthernet2/1/1] quit
# Configure Router D.
<RouterD> system-view
[RouterD] rip 1
[RouterD-rip-1] network 192.168.3.0
[RouterD-rip-1] network 192.168.4.0
[RouterD-rip-1] quit
Configure BFD parameters for the interfaces:
3.
# Configure Router A.
[RouterA] bfd session init-mode active
[RouterA] interface GigabitEthernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ip address 192.168.3.1 24
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface GigabitEthernet 2/1/2
[RouterA-GigabitEthernet2/1/2] ip address 192.168.1.1 24
[RouterA-GigabitEthernet2/1/2] bfd min-transmit-interval 500
[RouterA-GigabitEthernet2/1/2] bfd min-receive-interval 500
[RouterA-GigabitEthernet2/1/2] bfd detect-multiplier 7
[RouterA-GigabitEthernet2/1/2] quit
51