HPE FlexNetwork HSR6800 Configuration Manual page 260

Layer 3-ip routing configuration guide
Hide thumbs Also See for FlexNetwork HSR6800:
Table of Contents

Advertisement

Figure 77 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure EBGP connections:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] bgp 10
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] peer 200.1.2.2 as-number 20
[RouterA-bgp] network 9.1.1.0 255.255.255.0
[RouterA-bgp] quit
# Configure Router B.
<RouterB> system-view
[RouterB] bgp 20
[RouterB-bgp] router-id 2.2.2.2
[RouterB-bgp] peer 200.1.2.1 as-number 10
[RouterB-bgp] peer 200.1.3.2 as-number 30
[RouterB-bgp] quit
# Configure Router C.
<RouterC> system-view
[RouterC] bgp 30
[RouterC-bgp] router-id 3.3.3.3
[RouterC-bgp] peer 200.1.3.1 as-number 20
[RouterC-bgp] quit
# Display BGP routing table information on Router B.
[RouterB] display bgp routing-table 9.1.1.0
BGP local router ID : 2.2.2.2
Local AS number : 20
Paths:
BGP routing table entry information of 9.1.1.0/24:
From
Original nexthop: 200.1.2.1
AS-path
1 available, 1 best
: 200.1.2.1 (1.1.1.1)
: 10
248

Advertisement

Table of Contents
loading

Table of Contents