Configuring Preferences For Bgp Routes - HPE FlexNetwork HSR6800 Configuration Manual

Step
Enter system view.
1.
Enter BGP view or
2.
BGP-VPN instance view.
Specify a preferred value for
3.
routes received from a peer
or peer group.

Configuring preferences for BGP routes

A router can run multiple routing protocols with each having a preference. If they find the same route,
the route found by the routing protocol with the highest preference is selected.
You can use the preference command to modify preferences for external, internal, and local BGP
routes.
By default, the preference of an EBGP route is lower than a local route. If a device has an EBGP
route and a local route to reach a destination, the device does not select the EBGP route. You can
use the network shortcut command to configure an EBGP route as a shortcut route that has the
same preference as a local route. The EBGP route is then more likely to become the optimal route.
To configure preferences for BGP routes:
Step
Enter system view.
1.
Enter BGP view or
2.
BGP-VPN instance view.
Configure preferences for
3.
external, internal, local BGP
routes.
Increase the preference of a
4.
received EBGP route.
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance
view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
peer { group-name | ip-address }
preferred-value value
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance
view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
preference { external-preference
internal-preference
local-preference | route-policy
route-policy-name }
network ip-address [ mask |
mask-length ] short-cut
211
Remarks
N/A
Use either method.
Optional.
By default, the preferred value is
0.
Remarks
N/A
Use either method.
Optional.
The default preferences of
external, internal, and local BGP
routes are 255, 255, and 130,
respectively.
Optional.
By default, an EBGP route
received has a preference of 255.