HPE FlexNetwork HSR6800 Configuration Manual page 191

Figure 58 Network diagram
Device
Router A
Router C
Configuration procedure
Configure IP addresses for the interfaces on each router and configure IS-IS.
1.
Follow
shown.)
Configure IS-IS on the routers, ensuring that Router A, Router B, Router C, and Router D can
communicate with each other at Layer 3 and dynamic route update can be implemented among
them with IS-IS. (Details not shown.)
Configure MTR:
2.
# Create a rule for advanced IPv4 ACL 3001 to permit packets with DSCP value 11 to pass.
<RouterA> system-view
[RouterA] acl number 3001
[RouterA-acl-adv-3001] rule permit ip dscp 11
[RouterA-acl-adv-3001] quit
# Create a rule for advanced IPv4 ACL 3002 to permit packets with DSCP value 22 to pass.
[RouterA] acl number 3002
[RouterA-acl-adv-3002] rule permit ip dscp 22
[RouterA-acl-adv-3002] quit
# Create topologies voice and video. Specify ACL 3001 for topology voice, and ACL 3002 for
topology video.
[RouterA] address-family ipv4
[RouterA-address-family ipv4] multiple-topology voice
[RouterA-multiple-topology-voice] acl 3001
[RouterA-multiple-topology-voice] quit
[RouterA-address-family ipv4] multiple-topology video
Interface IP address
GE2/2/1 4.4.4.20/24
GE2/2/2 3.1.1.20/24
GE2/2/1 5.1.1.23/24
GE2/2/2 7.1.1.23/24
Loop0 4.4.4.4/32
Figure 58 to configure the IP address and subnet mask of each interface. (Details not
Device Interface
Router B GE2/2/1
GE2/2/2
GE2/2/3
Router D GE2/2/1
GE2/2/2
GE2/2/3
179
IP address
5.1.1.21/24
3.1.1.21/24
6.1.1.21/22
4.4.4.21/24
7.1.1.22/24
6.1.1.22/22