HPE FlexNetwork HSR6800 Configuration Manual page 362
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Figure 106 Network diagram
Configuration procedure
Configure IPv4 and IPv6 addresses for the interfaces on each router and configure IS-IS:
1.
Follow
the routers. (Details not shown.)
Configure IS-IS on the routers, making sure that Router A, Router B, Router C, and Router D
can communicate with each other at Layer 3 and dynamic route update can be implemented
among them with IS-IS. (Details not shown.)
Configure IPv6 IS-IS MTR:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] isis
[RouterA-isis-1] cost-style wide
[RouterA-isis-1] multiple-topology ipv6-unicast
# Configure Router B.
<RouterB> system-view
[RouterB] isis
[RouterB-isis-1] cost-style wide
[RouterB-isis-1] multiple-topology ipv6-unicast
# Configure Router D.
<RouterD> system-view
[RouterD] isis
[RouterD-isis-1] cost-style wide
[RouterD-isis-1] multiple-topology ipv6-unicast
Verify the configuration:
3.
# Display the IS-IS routing table of the IPv6 topology on Router A.
[RouterA-isis-1] display isis route ipv6
Destination: 12::
Flag
Figure 106
to configure the IPv4 and IPv6 address and subnet mask of each interface on
ISIS(1) IPv6 Level-1 Forwarding Table
-------------------------------------
: D/L/-
Route information for ISIS(1)
-----------------------------
350
PrefixLen: 64
Cost
: 4
Advertisement
Table of Contents
Troubleshooting
