Is-Is Configuration Examples; Is-Is Basic Configuration - HPE FlexNetwork HSR6800 Configuration Manual
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
IS-IS configuration examples
IS-IS basic configuration
Network requirements
As shown in
interconnected through IS-IS.
Router A and Router B are Level-1 routers, Router D is a Level-2 router, and Router C is a Level-1-2
router connecting two areas. Router A, Router B, and Router C are in area 10, and Router D is in
area 20.
Figure 50 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface serial 2/2/0
[RouterA-Serial2/2/0] isis enable 1
[RouterA-Serial2/2/0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface serial 2/2/0
[RouterB-Serial2/2/0] isis enable 1
[RouterB-Serial2/2/0] quit
# Configure Router C.
Figure
50, Routers A, B, C, and D reside in an autonomous system. They are
155
Advertisement
Table of Contents
Troubleshooting
