Configuring Bfd For Ospfv3 - HPE FlexNetwork HSR6800 Configuration Manual

Verify the configuration:
3.
# After all routers function correctly, perform a master/backup switchover on Router A to trigger
an OSPFv3 GR operation.

Configuring BFD for OSPFv3

Network requirements
As shown in
•
Configure OSPFv3 on Router A, Router B and Router C and configure BFD over the link Router
A<—>L2 Switch<—>Router B.
•
After the link Router A<—>L2 Switch<—>Router B fails, BFD can quickly detect the failure and
notify OSPFv3 of the failure. Then Router A and Router B communicate through Router C.
Figure 101 Network diagram
Device
Router A
Router C
Configuration procedure
Configure IP addresses for the interfaces. (Details not shown.)
1.
Configure OSPFv3 basic functions:
2.
# Configure Router A. Enable OSPFv3 and configure the router ID as 1.1.1.1.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-Gigabitethernet2/1/1] ospfv3 1 area 0
[RouterA-Gigabitethernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-Gigabitethernet2/1/2] ospfv3 1 area 0
[RouterA-Gigabitethernet2/1/2] quit
# Configure Router B. Enable OSPFv3 and configure the router ID as 2.2.2.2.
Figure 101:
Interface IPv6 address
GE2/1/1 2001::1/64
GE2/1/2 2001:2::1/64
GE2/1/1 2001:2::2/64
GE2/1/2 2001:3::1/64
Device Interface
Router B GE2/1/1
GE2/1/2
329
IPv6 address
2001::2/64
2001:3::2/64