HPE FlexNetwork HSR6800 Configuration Manual page 425
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Figure 116 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS:
2.
# Configure Router C.
<RouterC> system-view
[RouterC] isis
[RouterC-isis-1] is-level level-2
[RouterC-isis-1] network-entity 10.0000.0000.0001.00
[RouterC-isis-1] quit
[RouterC] interface Serial 2/2/1
[RouterC-Serial2/2/1] isis enable
[RouterC-Serial2/2/1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] isis enable
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface gigabitethernet 2/1/2
[RouterC-GigabitEthernet2/1/2] isis enable
[RouterC-GigabitEthernet2/1/2] quit
[RouterC] interface gigabitethernet 2/1/3
[RouterC-GigabitEthernet2/1/3] isis enable
[RouterC-GigabitEthernet2/1/3] quit
# Configure Router B.
[RouterB] isis
[RouterB-isis-1] is-level level-2
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface Serial 2/2/1
[RouterB-Serial2/2/1] isis enable
[RouterB-Serial2/2/1] quit
Configure OSPF and route redistribution:
3.
# Configure OSPF on Router A.
<RouterA> system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
413
Advertisement
Table of Contents
Troubleshooting
