Displaying And Maintaining Dldp; Dldp Configuration Examples; Automatically Shutting Down Unidirectional Links - HPE FlexNetwork HSR6800 series Configuration Manual

Resetting DLDP state in port view/port group view
Resetting DLDP state in port view or port group view applies to the current port or all ports in the port
group.
To reset DLDP state in port view/port group view:
Step
1. Enter system view.
2. Enter Ethernet interface
view/port group view.
3. Reset DLDP state.

Displaying and maintaining DLDP

Task
Display the DLDP configuration of
a port.
Display the statistics on DLDP
packets passing through a port.
Clear the statistics on DLDP
packets passing through a port.

DLDP configuration examples

Automatically shutting down unidirectional links

Network requirements
As shown in
Configure DLDP to automatically shut down the faulty port upon detecting a unidirectional link, and
automatically bring up the port after you clear the fault.
Command
system-view
•
•
dldp reset
Command
display dldp [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
display dldp statistics [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
reset dldp statistics [ interface-type
interface-number ]
Figure 9, Router A and Router B are connected with two fiber pairs.
Remarks
N/A
Enter Ethernet
interface view:
interface
Use either method.
interface-type
Configurations made in Ethernet interface
interface-number
view apply to the current port only.
Enter port group
Configurations made in port group view
view:
apply to all the ports in the port group.
port-group
manual
port-group-name
N/A
42
Remarks
Available in any view.
Available in any view.
Available in user view.