Configuring The P2Mp Network Type For An Interface; Configuring The P2P Network Type For An Interface - HPE FlexNetwork HSR6800 Configuration Manual

Step
Exit to system view.
5.
Enter OSPF view.
6.
Specify a neighbor and its
7.
router priority.

Configuring the P2MP network type for an interface

Step
Enter system view.
1.
Enter interface view.
2.
Configure the OSPF
3.
network type for the
interface as P2MP.
Exit to system view.
4.
Enter OSPF view.
5.
Specify a neighbor and its
6.
router priority.

Configuring the P2P network type for an interface

Step
Enter system view.
1.
Enter interface view.
2.
Configure the OSPF
3.
network type for the
interface as P2P.
Command
quit
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
peer ip-address [ cost value |
dr-priority dr-priority ]
Command
system-view
interface interface-type
interface-number
ospf network-type p2mp
[ unicast ]
quit
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
peer ip-address [ cost value |
dr-priority dr-priority ]
Command
system-view
interface interface-type
interface-number
ospf network-type p2p
68
Remarks
N/A
N/A
By default, no neighbor is specified.
Remarks
N/A
N/A
By default, the network type of an
interface depends on the link layer
protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are
unicast over the interface. The
interface cannot broadcast hello
packets to discover neighbors, so
you must manually specify the
neighbors.
N/A
N/A
Optional.
By default, no neighbor is specified.
This step must be performed if the
network type is P2MP unicast, and
is optional if the network type is
P2MP.
Remarks
N/A
N/A
By default, the network type of an
interface depends on the link layer
protocol.