HPE FlexNetwork HSR6800 Configuration Manual page 478

static, 1
static configuration, 6
static route BFD configuration, 7
router
IS-IS Level-1, 121
IS-IS Level-1-2, 121
IS-IS Level-2, 121
IS-IS system ID, 120
OSPFv3 router-LSA type, 302
routes
static, example configuration, 10
routing
assigning IS-IS high priority to routes, 145
BGP and IGP synchronization, 208
BGP route reflector, 190
BGP routing policies automatically take effect
disable, 226
configuring IS-IS dynamic
system-ID-to-host-name mapping, 147
configuring IS-IS static
system-ID-to-host-name mapping, 146
configuring IS-IS system-ID-to-host-name
mapping, 146
configuring OSPFv3 P2MP neighbor, 308
default. See default routing
enabling BGP MED route comparison from
confederation peer, 214
enabling BGP ORF capability, 220
enabling IS-IS LSP flash flooding, 143
enabling IS-IS neighbor state change
logging, 147
enabling OSPF RFC 1583 compatibility, 79
IP basics, 1
IPv6 BGP configuration, 352
IPv6 IS-IS basic configuration, 341
MP-BGP, 193
OSPF LSA type, 55
PBR configuration, 266
PBR policy configuration, 268
policy. See routing policy
RIP received/redistributed route filtering, 27
setting IS-IS LSDB overload bit, 146
specifying IS-IS CSNP packet send
interval, 140
specifying OSPF LSA arrival interval, 76
specifying OSPF LSA generation interval, 76
static routing. See static routing
table. See routing table
tuning BGP network, 219
routing policy
ACL filter, 405
apply clause configuration, 410
AS_PATH list, 405
AS_PATH list configuration, 407
BGP route filter policy application, 417
community list, 405
community list configuration, 407
configuration, 405, 408
continue clause configuration, 411
creation, 408
displaying, 412
extended community list, 405
extended community list configuration, 408
filter, 405
filter configuration, 406
filtering, 406
if-match clause configuration, 408
IP prefix list, 405
IP-prefix list configuration, 406
IPv4-prefix list configuration, 406
IPv6-prefix list configuration, 407
maintaining, 412
policy application to IPv4 route redistribution, 412
policy application to IPv6 route redistribution, 415
troubleshooting configuration, 419
troubleshooting IPv4 information filtering
failure, 419
troubleshooting IPv6 information filtering
failure, 419
routing table
direct route, 1
displaying, 3
dynamic route, 1
dynamic routing protocols, 2
information, 1
maintaining, 3
route preference, 2
static route, 1
S
security
applying IPsec policy to IPv6 BGP peer/peer
group, 366
configuring GTSM for IPv6 BGP, 367
OSPF interface authentication configuration, 78
OSPFv3 IPsec policy, 315, 332
RIPng IPsec policy, 293
security enhancement (IS-IS), 147
SEL (IS-IS NSAP selector), 120
selecting
BGP route, 189
BGP route selection, 189
466