Configuring Ripng Route Redistribution - HPE FlexNetwork HSR6800 Configuration Manual

----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost

Configuring RIPng route redistribution

Network requirements
•
Router B runs two RIPng processes. It communicates with Router A through RIPng 100 and
with Router C through RIPng 200.
•
Configure route redistribution on Router B, allowing the two RIPng processes to redistribute
routes from each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 94 Network diagram
Configuration procedure
Configure IPv6 addresses for the interfaces. (Details not shown.)
1.
Configure RIPng basic functions:
2.
# Enable RIPng 100 on Router A.
<RouterA> system-view
[RouterA] ripng 100
[RouterA-ripng-100] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-Gigabitethernet2/1/1] ripng 100 enable
[RouterA-Gigabitethernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-Gigabitethernet2/1/2] ripng 100 enable
# Enable RIPng 100 and RIPng 200 on Router B.
<RouterB> system-view
[RouterB] ripng 100
[RouterB-ripng-100] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-Gigabitethernet2/1/2] ripng 100 enable
[RouterB-Gigabitethernet2/1/2] quit
[RouterB] ripng 200
[RouterB-ripng-200] quit
[RouterB] interface gigabitethernet 2/1/1
on Gigabitethernet2/1/1
1, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
297