HPE FlexNetwork HSR6800 Configuration Manual page 49

Figure 8 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure basic RIP basic functions:
2.
# Enable RIP 100, and configure a RIPv2 on Router A.
<RouterA> system-view
[RouterA] rip 100
[RouterA-rip-100] network 10.0.0.0
[RouterA-rip-100] network 11.0.0.0
[RouterA-rip-100] version 2
[RouterA-rip-100] undo summary
[RouterA-rip-100] quit
# Enable RIP 100 and RIP 200, configure RIPv2 on Router B.
<RouterB> system-view
[RouterB] rip 100
[RouterB-rip-100] network 11.0.0.0
[RouterB-rip-100] version 2
[RouterB-rip-100] undo summary
[RouterB-rip-100] quit
[RouterB] rip 200
[RouterB-rip-200] network 12.0.0.0
[RouterB-rip-200] version 2
[RouterB-rip-200] undo summary
[RouterB-rip-200] quit
# Enable RIP 200 and configure RIPv2 on Router C.
<RouterC> system-view
[RouterC] rip 200
[RouterC-rip-200] network 12.0.0.0
[RouterC-rip-200] network 16.0.0.0
[RouterC-rip-200] version 2
[RouterC-rip-200] undo summary
[RouterC-rip-200] quit
# Display the routing table on Router C.
[RouterC] display ip routing-table
Routing Tables: Public
Destination/Mask
12.3.1.0/24
12.3.1.2/32
16.4.1.0/24
Destinations : 6
Proto Pre
Direct 0
Direct 0
Direct 0
Routes : 6
Cost NextHop
0 12.3.1.2
0 127.0.0.1
0 16.4.1.1
37
Interface
GE2/1/1
InLoop0
GE2/1/2