Verifying The Configuration - HPE FlexNetwork HSR6800 Configuration Manual

Layer 3-ip routing configuration guide

Hide thumbs Also See for FlexNetwork HSR6800:

Table of Contents

[RouterA] traffic classifier a

[RouterA-classifier-a] if-match acl ipv6 2000

[RouterA-classifier-a] quit

# Configure the action of redirecting traffic to GigabitEthernet 2/0/3 for the behavior a.

[RouterA] traffic behavior a

[RouterA-behavior-a] redirect interface gigabitethernet2/0/3

[RouterA-behavior-a] quit

# Associate the class a with the behavior a in the QoS policy a.

[RouterA] qos policy a

[RouterA-qospolicy-a] classifier a behavior a

[RouterA-qospolicy-a] quit

# Apply the QoS policy a to the inbound direction of GigabitEthernet 2/0/1.

[RouterA] interface gigabitethernet 2/0/1

[RouterA-GigabitEthernet2/0/1] qos apply policy a inbound

Verifying the configuration

After completing the configuration, verify that when Router A receives packets with destination IP

address 201::2, it forwards the packets to Router C instead of Router B.