Configuring Outbound Route Filtering - HPE FlexNetwork HSR6800 Configuration Manual

Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view.
Advertise a default route
4.
to an IPv6 peer or peer
group.
NOTE:
With the peer default-route-advertise command executed, the local router advertises a default
route with itself as the next hop to the specified IPv6 peer or peer group, regardless of whether the
default route is available in the routing table.

Configuring outbound route filtering

Step
Enter system view.
1.
Enter BGP view.
2.
Enter IPv6 address family
3.
view or IPv6 BGP-VPN
instance view.
Configure the filtering of
4.
outgoing routes.
Apply a routing policy to
5.
routes advertised to an IPv6
peer or peer group.
Specify an IPv6 ACL to filter
6.
routes advertised to an IPv6
peer or peer group.
Specify an AS path ACL to
7.
filter routes advertised to an
IPv6 peer or peer group.
Specify an IPv6 prefix list to
8.
filter routes advertised to an
IPv6 peer or peer group.
NOTE:
IPv6 BGP advertises routes passing the specified policy to peers. Using the protocol argument can
filter only the routes redistributed from the specified protocol. If no protocol is specified, IPv6 BGP
filters all routes to be advertised, including redistributed routes and routes imported with the
network command.
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name | ipv6-address }
default-route-advertise [ route-policy
route-policy-name ]
Command
system-view
bgp as-number
ipv6-family [ vpn-instance
vpn-instance-name ]
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name } export
[ protocol process-id ]
peer { ipv6-group-name | ipv6-address }
route-policy route-policy-name export
peer { ipv6-group-name | ipv6-address }
filter-policy acl6-number export
peer { ipv6-group-name | ipv6-address }
as-path-acl as-path-acl-number
export
peer { ipv6-group-name | ipv6-address }
ipv6-prefix ipv6-prefix-name export
358
Remarks
N/A
N/A
N/A
Not advertised by
default.
Remarks
N/A
N/A
N/A
Not configured by default.
Not applied by default.
The IPv6 BGP-VPN
instance view does not
support the
ipv6-group-name argument.
Not specified by default.
The IPv6 BGP-VPN
instance view does not
support this command.
Not specified by default.
The IPv6 BGP-VPN
instance view does not
support this command.
Not specified by default.
The IPv6 BGP-VPN
instance view does not
support this command.