Configuring Is-Is Route Redistribution - HPE FlexNetwork HSR6800 Configuration Manual

State: Up
[RouterD] display isis interface
Interface: GigabitEthernet2/1/1
Id
001

Configuring IS-IS route redistribution

Network requirements
As shown in
IS-IS to interconnect. Router A and Router B are Level-1 routers, Router D is a Level-2 router, and
Router C is a Level-1-2 router.
Redistribute RIP routes into IS-IS on Router D.
Figure 52 Network diagram
S2/2/0
10.1.1.2/24
S2/2/1
10.1.1.1/24
S2/2/0
10.1.2.1/24
Router B
L1
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure IS-IS basic functions:
2.
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface serial 2/2/0
[RouterA-Serial2/2/0] isis enable 1
[RouterA-Serial2/2/0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
HoldTime: 26s
Interface information for ISIS(1)
---------------------------------
IPV4.State
Up
Figure 52, Router A, Router B, Router C, and Router D reside in the same AS. They use
Router A
L1
S2/2/2
192.168.0.1/24
192.168.0.2/24
Router C
L1/L2
S2/2/0
10.1.2.2/24
Area 10
Type: L2
IPV6.State MTU
Down 1497
GE2/1/1
10.1.4.1/24
GE2/1/1
S2/2/0
10.1.4.2/24
Router D
L2
Area 20
163
PRI: 64
Type DIS
L1/L2 No/No
GE2/1/2
10.1.5.1/24
RIP
GE2/1/3
10.1.6.1/24
Router E