HPE FlexNetwork HSR6800 Configuration Manual page 118
Layer 3-ip routing configuration guide
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (503 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Figure 29 Network diagram
Configuration procedure
Configure IP address for interfaces. (Details not shown.)
1.
Configure OSPF basic functions:
2.
# Configure Router A
<RouterA> system-view
[RouterA] router id 1.1.1.1
[RouterA] ospf 100
[RouterA-ospf-100] area 0
[RouterA-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[RouterA-ospf-100-area-0.0.0.0] quit
# Configure Router B
<RouterB> system-view
[RouterB] router id 2.2.2.2
[RouterB] ospf 100
[RouterB-ospf-100] area 0
[RouterB-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255
[RouterB-ospf-100-area-0.0.0.0] quit
# Configure Router C
<RouterC> system-view
[RouterC] router id 3.3.3.3
[RouterC] ospf 100
[RouterC-ospf-100] area 0
[RouterC-ospf-100-area-0.0.0.0] network 192.1.1.0
[RouterC-ospf-100-area-0.0.0.0] quit
Configure OSPF GR:
3.
# Configure Router A as the non-IETF standard OSPF GR restarter: enable the link-local
signaling capability, the out-of-band re-synchronization capability, and non-IETF standard
Graceful Restart capability for OSPF process 100.
[RouterA-ospf-100] enable link-local-signaling
[RouterA-ospf-100] enable out-of-band-resynchronization
[RouterA-ospf-100] graceful-restart
[RouterA-ospf-100] return
0.0.0.255
106
Advertisement
Table of Contents
Troubleshooting
