Protocols and standards
•
RFC 1058, Routing Information Protocol
•
RFC 1723, RIP Version 2 - Carrying Additional Information
•
RFC 1721, RIP Version 2 Protocol Analysis
•
RFC 1722, RIP Version 2 Protocol Applicability Statement
•
RFC 1724, RIP Version 2 MIB Extension
•
RFC 2082, RIPv2 MD5 Authentication
•
RFC 2091, Triggered Extensions to RIP to Support Demand Circuits
•
RFC 2453, RIP Version 2
RIP configuration task list
Task
Configuring basic RIP
Configuring
RIP route
control
Tuning and
optimizing
RIP
networks
Configuring RIP FRR
Configuring
BFD for
RIP
Configuring basic RIP
Before you configure basic RIP settings, complete the following tasks:
Configuring an additional routing metric
Configuring RIPv2 route summarization
Disabling host route reception
Advertising a default route
Configuring received/redistributed route filtering
Configuring a preference for RIP
Configuring RIP route redistribution
Configuring RIP timers
Configuring split horizon and poison reverse
Configuring the maximum number of ECMP routes
Enabling zero field check on incoming RIPv1 messages
Enabling source IP address check on incoming RIP updates
Configuring RIPv2 message authentication
Specifying a RIP neighbor
Configuring RIP-to-MIB binding
Configuring the RIP packet sending rate
Enabling single-hop echo detection (for a directly connected RIP neighbor)
Configuring single-hop echo detection (for a specific destination)
Enabling bidirectional control detection
22
Remarks
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.