HPE FlexNetwork HSR6800 Configuration Manual page 58

Configure a static route on Router C:
4.
[RouterC] ip route-static 100.1.1.1 24 null 0
Verify the configuration:
5.
# Display the BFD session information of Router A.
<RouterA> display bfd session
Total Session Num: 1
Session Working Under Echo Mode:
LD SourceAddr
3 192.168.1.1
# Display RIP routes destined for 100.1.1.0/24 on Router A.
<RouterA> display ip routing-table 100.1.1.0 24 verbose
Routing Table : Public
Summary Count : 2
Destination: 100.1.1.0/24
Protocol: RIP
Preference: 100
IpPrecedence:
NextHop: 192.168.1.2
BkNextHop: 0.0.0.0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Active Adv
Tag: 0
Destination: 100.1.1.0/24
Protocol: RIP
Preference: 100
IpPrecedence:
NextHop: 192.168.2.2
BkNextHop: 0.0.0.0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Inactive Adv
Tag: 0
# Enable RIP event debugging on Router A.
<RouterA> debugging rip 1 event
<RouterA> terminal debugging
# When the link over GigabitEthernet 2/1/1 fails, Router A quickly detects the link state change.
%Jan 19 10:41:51:203 2008 RouterA BFD/4/LOG:Sess[192.168.1.1/192.168.1.2,
GE2/1/1,Ctrl], Sta: UP->DOWN, Diag: 1
*Jan 19 10:33:12:813 2008 RouterA RM/6/RMDEBUG: RIP-BFD: Message Type Disable, Connect
Type Direct-connect, Pkt Type Echo, Src IP Address 192.168.1.1, Src IFIndex4, Nbr IP
Address 192.168.1.2.
# Display the BFD information of Router A.
<RouterA> display bfd session
The output shows that Router A has deleted the BFD session to Router C and displays no
output.
Init Mode: Active
DestAddr State
192.168.1.2 Up
Process ID: 1
Cost: 1
QosLcId:
Interface: GigabitEthernet2/1/1
BkInterface:
Neighbor : 192.168.1.2
Label: NULL
BKLabel: NULL
Age: 00h00m47s
Process ID: 2
Cost: 2
QosLcId:
Interface: GigabitEthernet2/1/2
BkInterface:
Neighbor : 192.168.2.2
Label: NULL
BKLabel: NULL
Age: 00h12m50s
46
Holdtime Interface
2000ms GE2/1/1