Configuring A Continue Clause - HPE FlexNetwork HSR6800 Configuration Manual

Step
Set the next hop.
9.
10. Set the IP precedence.
11. Inject routing information to a
specified ISIS level.
12. Set the local preference for
BGP routing information.
13. Set MPLS label.
14. Set the origin attribute for
BGP routes.
15. Set the preference for the
routing protocol.
16. Set a preferred value for BGP
routes.
17. Set the QoS-local ID.
18. Set a tag value for RIP, OSPF
or IS-IS route.
19. Configure FRR.

Configuring a continue clause

Follow these guidelines when you configure a continue clause:
•
If you configure the same apply clause that set different values (including the apply
community and apply extcommunity clauses with the additive keyword) on nodes that are
combined by the continue clause, the apply clause configured on the last matching node takes
effect.
•
If you configure the apply community clause for multiple nodes that are combined by the
continue clause, the apply comm-list delete clause configured on the current node cannot
delete the community attributes set by preceding nodes.
To configure a continue clause for a routing policy:
Command
•
Set the next hop for IPv4
routes:
apply ip-address next-hop
ip-address
•
Set the next hop for IPv6
routes:
apply ipv6 next-hop
ipv6-address
apply ip-precedence
ip-precedence-value
apply isis { level-1 | level-1-2 |
level-2 }
apply local-preference preference
apply mpls-label
apply origin { egp as-number | igp
| incomplete }
apply preference preference
apply preferred-value
preferred-value
apply qos-local-id local-id-value
apply tag value
apply fast-reroute
backup-interface interface-type
interface-number
[ backup-nexthop ip-address ]
411
Remarks
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not configured by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not set by default.
Optional.
Not configured by default.