HPE FlexNetwork HSR6800 Configuration Manual page 104

Figure 23 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure OSPF basic functions (see
2.
Configure OSPF to redistribute routes:
3.
# On Router C, configure a static route destined for network 3.1.2.0/24.
<RouterC> system-view
[RouterC] ip route-static 3.1.2.1 24 10.4.1.2
# On Router C, configure OSPF to redistribute the static route.
[RouterC] ospf 1
[RouterC-ospf-1] import-route static
Verify the configuration:
4.
# Display ABR/ASBR information on Router D.
<RouterD> display ospf abr-asbr
Type
Intra
Inter
# Display the OSPF routing table of Router D.
<RouterD> display ospf routing
Routing for Network
Destination
10.2.1.0/24
10.3.1.0/24
10.4.1.0/24
10.5.1.0/24
10.1.1.0/24
Routing for ASEs
OSPF Process 1 with Router ID 10.5.1.1
Routing Table to ABR and ASBR
Destination
10.3.1.1
10.4.1.1
OSPF Process 1 with Router ID 10.5.1.1
Routing Tables
Cost
22
10
25
10
12
"Configuring OSPF basic
Area Cost
0.0.0.2 10
0.0.0.2 22
Type NextHop
Inter 10.3.1.1
Transit 10.3.1.2
Inter 10.3.1.1
Stub 10.5.1.1
Inter 10.3.1.1
92
functions").
Nexthop RtType
10.3.1.1 ABR
10.3.1.1 ASBR
AdvRouter Area
10.3.1.1 0.0.0.2
10.3.1.1 0.0.0.2
10.3.1.1 0.0.0.2
10.5.1.1 0.0.0.2
10.3.1.1 0.0.0.2