Specifying A Rip Neighbor; Configuring Rip-To-Mib Binding; Configuring The Rip Packet Sending Rate - HPE FlexNetwork HSR6800 Configuration Manual

To configure RIPv2 message authentication:
Step
Enter system view.
1.
Enter interface view.
2.
Configure RIPv2 authentication.
3.

Specifying a RIP neighbor

Usually, RIP sends messages to broadcast or multicast addresses. On non-broadcast or multicast
links, you must manually specify RIP neighbors.
Follow these guidelines when you specify a RIP neighbor:
•
Do not use the peer ip-address command when the neighbor is directly connected. Otherwise,
the neighbor might receive both the unicast and multicast (or broadcast) of the same routing
information.
•
If a specified neighbor is not directly connected, disable source address check on incoming
updates.
To specify a RIP neighbor:
Step
Enter system view.
1.
Enter RIP view.
2.
Specify a RIP neighbor.
3.
Disable source address
4.
check on incoming RIP
updates.

Configuring RIP-to-MIB binding

This task allows you to enable a specific RIP process to receive SNMP requests.
To bind RIP to MIB:
Step
Enter system view.
1.
Bind RIP to MIB.
2.

Configuring the RIP packet sending rate

Perform this task to specify the interval for sending RIP packets and the maximum number of RIP
packets that can be sent at each interval. This feature can avoid excessive RIP packets from
affecting system performance and consuming too much bandwidth.
Command
system-view
interface interface-type interface-number
rip authentication-mode { md5 { rfc2082 [ cipher ]
key-string key-id | rfc2453 [ cipher ] key-string } | simple
[ cipher ] password }
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
peer ip-address
undo validate-source-address
Command
system-view
rip mib-binding process-id
31
Remarks
N/A
N/A
N/A
By default, this function is not
disabled.
Remarks
N/A
Optional.
By default, MIB is bound to RIP
process 1.