HPE FlexNetwork HSR6800 Configuration Manual page 212

Step
Configure a description for a
7.
peer group.
To configure an EBGP peer group by using Method 2:
Step
Enter system view.
1.
Enter BGP view or
2.
BGP-VPN instance view.
Create an EBGP peer group
3.
Create a BGP peer and
4.
specify its AS number.
Add a peer into the EBGP
5.
peer group.
Enable the default use of
6.
IPv4 unicast address family
for the peers that are
established using the peer
as-number command.
Enable a peer.
7.
Configure a description for a
8.
peer group.
To configure an EBGP peer group by using Method 3:
Step
Enter system view.
1.
Enter BGP view or
2.
BGP-VPN instance view.
Create an EBGP peer group.
3.
Command
peer group-name description
description-text
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance
view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
group group-name external
peer ip-address as-number
as-number
peer ip-address group
group-name [ as-number
as-number ]
default ipv4-unicast
peer ip-address enable
peer group-name description
description-text
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance
view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
group group-name external
200
Remarks
Optional.
By default, no description is
configured for the peer group.
Remarks
N/A
Use either method.
N/A
N/A
The as-number as-number
option, if used, must specify the
same AS number as the peer
ip-address as-number
as-number command.
Optional.
Enabled by default.
This command is not supported in
BGP-VPN instance view.
Optional.
Enabled by default.
Optional.
By default, no description is
configured for the peer group.
Remarks
N/A
Use either method.
N/A