Alcatel-Lucent 7950 Quality Of Service Manual page 542

RED Slope Commands
The no form of this command restores the drop-rate value to the default setting.
Default
drop-rate 1 — High slope default is 1 (6.25 drop-rate) for all the queues, this implies that once the
shared buffer utilization reaches the start-threshold level then packets egressing out from a
particular queue would be dropped at 6.25% rate.
drop-rate 0 — Low slope default is 0 (100% drop-rate) for all the queues, this implies that once the
shared buffer utilization reaches the start-threshold level then packets egressing out from a
particular queue would be dropped at 100% rate.
Parameters
queue-id —
Values
drop-rate num —
Values
Page 542
Specifies the ID of the queue for which the drop-rate is to be configured.
1 — 8
Specifies the drop rate to be configured.
0 — 7
7950 XRS Quality of Service Guide