Alcatel-Lucent 7950 Quality Of Service Manual page 219

prec ip-prec-value — This parameter is one of two mutually exclusive settings that are applicable to the in-
remark command. The in-remark command can be configured to either remark the DiffServ Code Point
(DSCP) six bit value or the three Precedence bits. The prec parameter specifies that the matching
packets Precedence bits should be overridden with the value represented by prec-value.
Values
Default
multicast-queue
Syntax multicast-queue queue-id [group queue-group-name]
Context config>qos>sap-ingress>fc fc-name
Description
This command overrides the default multicast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a multipoint queue before the mapping can be made. Once the
forwarding class mapping is executed, all multicast traffic on a SAP using this policy is forwarded using the
queue-id.
The multicast forwarding type includes the unknown unicast forwarding type and the broadcast forwarding
type unless each is explicitly defined to a different multipoint queue. When the unknown and broadcast
forwarding types are left as default, they will track the defined queue for the multicast forwarding type.
The no form of the command sets the multicast forwarding type queue-id back to the default queue for the
forwarding class. If the broadcast and unknown forwarding types were not explicitly defined to a
multipoint queue, they will also be set back to the default multipoint queue (queue 11).
Parameters
queue-id — The queue-id parameter specified must be an existing, multipoint queue defined in the
config>qos>sap-ingress context.
Values
Default
group queue-group-name — This optional parameter is used to redirect the forwarding type within the for-
warding class to the specified queue-id within the queue-group-name. When the policy is applied, all
packets matching the forwarding class and forwarding type will be redirected to the queue within the
specified queue group. The queue-group-name are configured in the config>qos>queue-group-tem-
plates egress and ingress contexts.
out-remark
Syntax out-remark dscp dscp-name
out-remark prec ip-prec-value
no out-remark
Context config>qos>sap-ingress>fc fc-name
Description This command is used in a SAP ingress QoS policy to define an explicit out-of-profile remark action for a
forwarding class or sub-class. While the SAP ingress QoS policy may be applied to any SAP, the remarking
7950 XRS Quality of Service Guide
0 — 7
None (an explicit precedence value must be specified)
Any valid multipoint queue-ID in the policy including 2 through 32.
11
Page 219