Alcatel-Lucent 7950 Quality Of Service Manual page 110

Generic Commands
Operational Commands
copy
Syntax copy network src-pol dst-pol [overwrite]
Context config>qos
Description
This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is used to create new policies using existing policies and also allows bulk
modifications to an existing policy with the use of the overwrite keyword.
Parameters network src-pol dst-pol — Indicates that the source and destination policies are network policy IDs.
Specify the source policy that the copy command will copy and specify the destination policy to which
the command will duplicate the policy to a new or different policy ID.
Values
overwrite — Specifies to replace the existing destination policy. Everything in the existing destination
policy will be overwritten with the contents of the source policy. If overwrite is not specified, an error
will occur if the destination policy ID exists.
SR>config>qos# copy network 1 427
MINOR: CLI Destination "427" exists use {overwrite}.
SR>config>qos# copy network 1 427 overwrite
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>network policy-id
Description
This command configures the network policy scope as exclusive or template.
The no form of this command sets the scope of the policy to the default of template.
Default template
Parameters
exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one
interface. If a policy with an exclusive scope is assigned to a second interface an error message is
generated. If the policy is removed from the exclusive interface, it will become available for assignment
to another exclusive interface.
The system default policies cannot be put into the exclusive scope. An error will be generated if scope
exclusive is executed in any policies with a policy-id equal to 1.
Page 110
1 — 65535
7950 XRS Quality of Service Guide