Service Management Tasks; Deleting Qos Policies; Remove A Qos Policy From Service Sap(S) - Alcatel-Lucent 7950 Quality Of Service Manual

Service Management Tasks

This section discusses the following service management tasks:
•
•
•
•

Deleting QoS Policies

Every service SAP is associated, by default, with the appropriate egress or ingress policy (policy-
id 1). You can replace the default policy with a customer-configured policy, but you cannot
entirely remove the policy from the SAP configuration. When you remove a non-default service
egress or ingress policy, the association reverts to the default policy-id 1.
A QoS policy cannot be deleted until it is removed from all SAPs where they are applied.
A:ALA-7>config>qos# no sap-ingress 100
MINOR: CLI SAP ingress policy "100" cannot be removed because it is in use.
A:ALA-7>config>qos#

Remove a QoS Policy from Service SAP(s)

The following service output examples show that the SAP service ingress reverted to policy-id "1"
when the non-default policies were removed from the configuration.
7950 XRS Quality of Service Guide
Deleting QoS Policies on page 159
Copying and Overwriting QoS Policies on page 160
Remove a Policy from the QoS Configuration on page 161
Editing QoS Policies on page 161
Service Egress and Ingress QoS Policies
Page 159